Change the Battery in the Zune 8Gb
Template:AttentionWant to change the Zune player battery and give it a new lease on life? This DIY article shows you the easiest steps to replace it.
Steps
- Order a replacement battery for your Zune.
- Follow this link on how to disassemble the device: http://www.rapidrepair.com/guides/zune2/Flash-Zune-8GB-Take-Apart-Guide.htm
- Stop at step 6a:
- Locate the fake metal plate on top of the device. Use a flat tip and pry out the cover.
- Take out the 2 screws. You need a special tri-tip one or use a small flat head.
- Use your fingernail and pry out the back cover.
- Remove the battery which is held in place a a glob of glue. So you need to apply a little bit of force, and do not worry about deforming the battery.
- Use a sharp Exacto knife a side open the top of the battery to expose the small PCB which is attached to the battery by 2 tabs. Carefully mark the polarity of the tabs by use a DVM. Unsolder the battery tabs, and remove the battery.
- Perform the above steps on the new battery. Make sure to use a DVM to mark the battery tab polarity; you don't want to short the VDD to GND! Remove the battery and throw away the new PCB.
- Solder the new battery to the old PCB. Make sure of the correct polarity when solder the battery tabs to the old PCB.
- Fold back the PCB and tape it to the battery by using either Kapton polyimide film or electrical tape.
- Snap back the cover, and put back the 2 screws. Snap on the fake metal cover.
- Your Zune is now brand new!