Check a Thermostat in a Dryer

Revision as of 21:46, 8 January 2016 by Kipkis (Kipkis | contribs) (importing article from wikihow)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

The thermostat in your clothes dryer is an important component to the unit. If you've ever pulled clothes out only to find that they were still damp, or found that your dryer was not shutting off at the timer, the thermostat may be the first thing to troubleshoot. Thermostats regulate the heat used in the drying process. If the thermostat is faulty, you may need to replace it. You can use these steps to determine if your thermostat is the cause of malfunction, or if you have another heating component that's not operating properly.

Steps

  1. Turn off the electrical power to your dryer. Unplug the appliance from the wall, or cut the circuit to the dryer at the main fuse or breaker box.
  2. Access the dryer's rear panel. Pull the dryer from the wall and locate the rear access panel.
    • Remove the metal screws of the panel with a Phillips screwdriver.
  3. Locate the thermostat. Check the blower wheel housing and vent systems and look for a small, oval thermostat, about 1 1/2 inches (3.81 cm) in length.
  4. Detach the thermostat wires. The dryer thermostat will have 2 wires connecting it to the heating element. Label each wire prior to removal so you will know how to reconnect them.
    • Identify the metal slip connector attached to the wires.
    • Pull the wires by these connectors. If necessary, use needle-nose pliers.
  5. Measure the thermostat's ohms. Ohms are used to indicate electrical flow.
    • Use a multimeter to test the thermostat's resistance by setting it to the RX 1 setting.
    • Place each of the meter's probes onto the wire terminals. You should receive a reading of 0. Resistance that is low, or near 0, means that the electrical flow is good. If the meter does not indicate 0, but reads infinity, your thermostat should be replaced.

Video

Tips

  • If your thermostats reading are normal, you will need to troubleshoot the dryer's timer, thermal fuses, motor or heating elements.
  • Test your thermostat at room temperature for best results.

Warnings

  • Always cut the power supply when working with electrical equipment to avoid shock.

Things You'll Need

  • Phillips screwdriver
  • Needle-nose pliers
  • Multimeter

Related Articles

Sources and Citations