Check an Ignition Coil on an Aircooled Volkswagen Beetle

Revision as of 22:18, 23 March 2017 by Kipkis (Kipkis | contribs) (importing article from wikihow)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Before checking the ignition coil, ensure there is 12V going to the terminal 15 on the coil. Note: Terminal 15 is positive, terminal 1 is negative. Turn your ignition switch to "on" and put a test light or meter on the coil, one lead to plus, the other to minus. The light should go on or the meter should indicate the voltage. Use extreme caution.

Steps

  1. Be sure to have a fire extinguisher nearby!!
  2. Use extreme caution.
  3. Pull the wire out of the center of the distributor with a rubber handled pair of pliers, and hold it about 1/4" from the metal clips that holds the distributor cap on.
  4. Have someone crank over the engine.
    • There should be a nice blue spark that goes from the end of the wire you pulled out of the center of the cap to the metal clip.
      • It should look and sound strong, and should be easy to see, even in daylight.
    • If the spark looks thin and weak (yellow is weak, blue is strong), then the coil winding may be giving out.
  5. Use an Ohmmeter to test the coil
    • Remove all the wires taken off the terminals of the coil attach the positive and negative, red and black, wires of the meter to first the terminal 15 (positive) and 1 (negative) that are stamped on the coil.
      • A reading of at least 3 - 4.5 ohms, indicates a good coil.
      • A bad coil will show a higher reading then 3 - 4.5 ohms.
    • Place the red or black lead from the meter to the center of the coil (secondary post), and to either one of the terminals, 1 or 15 on the coil.
      • A reading of 9,500 - 10,000 Ohms, sometimes less, indicates a good coil.
      • A reading of 11,000 Ohms or more, or a reading of zero indicates a bad coil.

Video

Warnings

  • Use extreme caution and be sure to have a fire extinguisher nearby!
  • Safety should always be your #1 focus when working on a vehicle. Absolutely nothing in this world is so important, that you should ever practice unsafe maintenance on your vehicles. Always use the proper tools for the job at hand. Common sense is a very important in following any directions for maintenance.

Related Articles