Remove Water from Inside a Watch Face
Revision as of 02:15, 26 April 2022 by Kipkis (Kipkis | contribs) (Text replacement - "[[Category:J" to "[[Category: J")
Template:StubHow to remove water or condensation from inside the face of a watch.
Steps
- Remove the back as if you were changing the battery.
- There are several ways to remove the water:
- Lay the watch face down, on a cloth, in the sun.
- Lay it down in front of a fan or a register grate.
- Use the "low heat" setting of a hair dryer on the watch.
- Before replacing the back, check the rubber seal is in the right place. Replace if worn out or add a small quantity of Vaseline if in good condition. This should prevent future water problems.
