Kill English Ivy

English ivy may be pleasing to the eye, but when it quietly creeps across the ground and up trees and buildings, it can leave extreme damage in its wake. The small, suction cup-like "holdfasts" with which ivy attaches to vertical surfaces are strong enough to rip off chunks of bark or paint. Killing ivy without causing further damage to your property requires cutting the vines, rolling them back and mulching them to make sure they won't take root again.

Steps

Killing Ivy on Trees

1. Get your equipment ready. The most important tool you'll need in order to kill ivy is a sharp pair of clippers or loppers, depending upon the thickness of the vines. Older vines can grow as thick as one's arm, while newer vines are as thin as flower stems. In addition to gathering appropriate cutting supplies, put on a thick pair of gardening gloves to protect your hands as you pull the ivy back.
2. Cut the vines around the base of the tree. One by one, walk around the tree and cut through every vine growing up the tree at ankle height. Even one remaining uncut vine can nourish the ivy further up the tree, so it's important to make sure no vine is left behind.
   • For very old, thick vines, use a handsaw to carefully saw through the vine.
   • As you work, be careful not to make cuts on the tree itself. Ivy weakens trees and makes them more susceptible to disease. Cutting through the bark could cause further damage.
3. Cut another circle around the tree at shoulder level. Use the same technique to cut all the vines again. This time, pull the cut sections of vines gently from the tree as you go. By making two cuts and pulling away the section of ivy at the bottom of the tree, you're blocking the vines higher up the tree from getting essential nutrients, and they'll soon die. Put the cut vines in a pile, then mulch them later so they won't take root again.
   • As you pull the cut vines from the tree, be careful not to remove too much bark with the holdfasts.
   • The same method works for removing ivy from outdoor walls.
4. Examine the tree trunk for uncut vines. Take a close look to make sure no vines were left uncut. Cut and remove any you happen to find, taking care not to damage the bark.
5. Cut away the ivy on the ground. If the tree is surrounded by a mat of ivy on the ground, you'll need to remove the ivy from the ground so that it won't climb back up the tree. Removing a donut-shaped mat of ivy from around the base of the tree is sometimes referred to as a "lifesaver" cut. Here's how to do it:
   • Start by cutting a line through the ivy along the ground, from the base of the tree to a distance {{safesubst:#invoke:convert|convert}} away. Cut several more lines radiating from the tree. Cutting the ivy into sections will make it easier to remove.
   • Make a cut that connects all the lines {{safesubst:#invoke:convert|convert}} from the base of the tree.
   • Start pulling up the mats of ivy section by section. Keep removing ivy until you've cleared the area around the base of the tree such that no ivy reaches within {{safesubst:#invoke:convert|convert}} of it.
6. Wait for the ivy to die. Now that you've cleared the base of the tree, the ivy growing above shoulder height will begin to shrivel and turn brown. Do not attempt to cut away or pull off vines that have grown above your shoulders. Yanking off the holdfasts will pull away the tree's bark, leaving it susceptible to disease. The dead ivy will look unattractive at first, but eventually the leaves will fall away and it will become less noticeable.
7. Monitor the area for new ivy growth. After you've taken these measures, check back every few weeks to make sure new ivy isn't crawling in the vicinity of the tree. When you find some, cut it away.

Killing Ivy on the Ground

1. Cut the ivy into sections. Cut lines through the ivy along the ground in order to divide it into large sections. This will make it much easier to remove the ivy from the ground. Pull the sections apart from one another as you cut. Work carefully around plants and saplings you want to keep.
   • If you're working on a hill, cut vertical lines from the top of the hill to the bottom to create sections that you can roll downhill.
2. Roll the sections off the ground. Lift the edge of one section of ivy and roll it forward on top of itself. Keep rolling the ivy forward until the entire section has been rolled up into a big log of ivy. Move the log to a separate area and continue rolling up sections until you've cleared the area.
   • Mulching the ivy rolls is the best way to dispose of them and ensure they won't take root in the area again.
3. Use herbicides as an alternative. English ivy is difficult to kill with herbicides alone because the plant's leaves contain a waxy barrier that is difficult for products to penetrate. Therefore, the most effective method is to combine manual removal with the use of a herbicide. Glyphosate is the chemical that works most effectively to kill English ivy.
   • Spray the area of ivy you wish to kill, but be careful the glyphosate doesn't reach other plants you want to keep.
   • Herbicides are slow-acting, and must be reapplied every six weeks or so.
4. Use mulch to contain ivy you want to keep. If you have a patch of ivy you want to preserve, but you'd like to prevent it from spreading, you can use mulch to keep it contained. Simply cover the border of the the ivy you want to keep with several inches (about 7 to 8 inches) of shredded or wood chip mulch. You will need to give this method some time; leave the mulch on the ivy for at least 2 seasons. You may need to add new mulch one or more times during a growing season.
   • Another option is to trim the ivy back to contain it. Use a weed eater or edging tool to cut the vines along the border.

Tips

• Always wear gloves and long sleeves to protect your arms when cutting or pulling ivy.

Warnings

• Do not add ivy cuttings or roots to a compost pile. This will likely cause it to grow and spread to areas where you use the compost.
• Wear goggles to protect eyes from debris and snapping ivy.
• Be especially careful when cutting or pulling the vine off trees because you can damage the tree bark, exposing the tree to invasive organisms or pests which could harm or kill the tree.

Things You'll Need

• Pruning shears
• Protective gloves
• Protective goggles
• Shovel
• Rake
• Disposable garden bags
• Mulcher or mower
• Herbicide

Related Articles

• Grow English Ivy
• Plant English Ivy
• Remove an Ivy Plant
• Set up an English Garden

Sources and Citations

See also

• Handle and Apply Pesticides Safely
• Get Rid of House and Garden Pests
• Clear Ants off a Deck
• Protect Garden Berries
• Deter Possums from Your Garden
• Get Rid of Millipedes
• Get Rid of Deer
• Kill a Stink Bug
• Get Rid of Animal Pests With Hot Pepper Spray
• Get Rid of a Beehive

Read more ...

What links here

• Kill Ivy Without Damaging a Tree
• Prevent Getting Poison Ivy or Poison Oak
• Remove an Ivy Plant