Make a Minnow Trap

Revision as of 02:44, 10 August 2016 by Kipkis (Kipkis | contribs) (importing article from wikihow)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Tired of buying your own fishing bait every week? With little more than some string and an old plastic 2-liter soda bottle you can craft your own minnow trap, catching your own minnows in a nearby stream.

You Will Need

  • 2 two-liter soda bottle
  • heavy string or fishing line
  • Box cutter or sturdy knife
  • duct tape or super glue
  • Bread or breadcrumbs
  • Sand, dirt, or rocks.

Steps

  1. Cut the bottom off of one of the bottles. Cut the bottle into two pieces 2-3 inches above the bottom . Discard the bottom and keep the cap on the top.
    • While box cutters usually cut the best, a serrated bread knife works well too.
  2. Punch 10-15 small holes into the sides of the bottle. These will allow water into the trap. Using either the tip of a knife or a hot nail (heat will cause the plastic to melt), put a few 1 centimeter holes around the middle of the bottle.
  3. Thread fishing line through two holes and tie it together to create a handle. Simply run your string or fishing line through two holes, then tie a knot between the two ends to make a simple handle. This will make it easier to remove the trap later.
  4. Cut the top off of the other bottle. Cut just below the point where the top meets the "body" of the bottle. You will be left with a a cylinder and a tapered top section. Keep the top and discard the cap and the bottom cylinder.
  5. Slide the top of one bottle into the bottom of the other one. This is the entrance for the minnows -- they are funneled into the hole by the tapered top and then trapped inside the body of the other bottle.
  6. Secure the two bottles together with duct-tape. You can also punch holes in both bottles with a hot nail -- this will melt the plastic together.
  7. Cut up a slice of bread and push it into the trap. This is your bait. One inch pieces should be big enough. You can also put some sand, dirt, or rocks in the trap to help it sink and keep it from floating away.
  8. Place your trap at the bottom of a shallow stream. Minnows tend to swarm in shallow, slow moving pools of water. You can often see them from the shore, so put your trap somewhere you will get plenty of "bites."
    • Push the trap lightly underwater so it fills up and sinks.
  9. Return after a day to get your minnows. The fish will be funneled into the trap, but are unable to find their way back through the small hole made with the top of the bottle. You can unscrew the bottom of your trap to get the minnows out, then screw it back up to use again.

Video

Tips

  • Weight the trap so the fish don't swim away.

Warnings

  • As always, take care when handling sharp objects.
  • Watch out for minnow bites.

You may like