Build A Darkroom

Even with the advent of modern technology, using an old school camera gives your photographs a unique look. In addition, printing your own photographs can be a rewarding experience and a fun hobby. The most important requirement for this hobby is your darkroom and setting up this workspace is crucial. This doesn’t have to be complicated or expensive. You just need to make sure you to find the right space and set up the necessary equipment.

Steps

Setting Up Your Space

1. Find a room in your home that can be made totally dark. A room with no windows is usually best, otherwise try to find a room with few small windows. A bathroom or basement room are usually best for this purpose. This room doesn’t have to be particularly big; a 25 square foot space is sufficient.
   • Make sure this room has an outlet for your equipment.
   • Running water can also be useful but isn’t required.
2. Ensure the room is well-ventilated. If you situate your darkroom in a bathroom, you usually have a bathroom fan which can help keep the room ventilated. However, this is not ideal in the long run; chemicals are heavier than air, and most bathroom fans will struggle to completely clear the air. You’ll eventually want to invest in more powerful fans to preserve your health.
3. Have a table or countertop in your darkroom. If space permits, this surface will make setting up your equipment and developing photos much easier. A desk with drawers will allow you to store some of your supplies, especially important if your darkroom has other purposes. Make sure your photo paper is stored in a drawer that doesn’t let light in.
4. Get your space completely dark. If your future darkroom has windows, you’ll need more than curtains or blinds to make it completely dark. Take some black fabric, cut slightly larger than the windows, and tape it around the edges of the windows. Alternatively, you can use cardboard or thin plywood to block of windows, with fabric and tape around the edges to completely seal out light. If light leaks in around the door, affix a strip of fabric along its edge in the same manner.
   • You’ll have an easier time spotting encroaching light by turning off the room’s lights. As your eyes adjust to the dark, you’ll have an easier time spotting places where the light leaks in.
5. Split your darkroom in two halves; a "wet" side and a "dry" side. You’ll want to establish this separation before you start setting up your equipment. This will protect your photos from costly mistakes, as well as make sure you don’t damage your equipment. The dry side will include your electronic equipment and should be close to the outlet. Having running water near the wet side of your darkroom will make the development process much simpler.
   • Make sure to check the water quality in your darkroom; errant particles can negatively impact the development process. Run the water over a tray for 15 minutes. If there are visible particles at the bottom of the tray, you’ll need a water filter.

Equipping Your Darkroom

1. Buy used supplies. If you’re particularly knowledgeable, you can save quite a bit of money buying used. Check with friends or family in the hobby for hand me downs; knowing the previous owner means you’re more likely to get a good deal. You can also find used photo development gear on eBay and Craigslist. Make sure to check the condition of the equipment before buying.
   • If you live near a college, check campus bulletin boards near the end of semesters for ads from students looking to offload supplies.
2. Choose your enlarger carefully. The enlarger is the centerpiece of the darkroom, as well as the most expensive piece of equipment you’ll need to acquire. If you’re new to the hobby, look for an entry level enlarger that’s easy to use and store. Beseler has a line of enlargers aimed at newbies, made for developing 35mm film. These models also come with lenses. Not all enlargers come with a lens, especially at higher price ranges.
3. Acquire your printing kit. You’ll get the best deal picking and choosing each article, but this requires a minimum of knowledge. Several companies have complete darkroom kits available; these give you all the equipment you need without having to shop around. Keep in mind that some of these don’t include an enlarger, but will provide you with most of the equipment you’ll need.
4. Acquire and arrange your chemicals. Developing photographs requires three specific chemical solutions. You’ll need developer, fixer and stop bath. The first two of these can be purchased from photography speciality store, while there are more options for your stop bath. You can either purchase acetic acid, pickling vinegar or a specialized premixed stop bath solution.
   • Make sure your trays and tongs are clearly marked, as putting chemicals in the wrong tray can contaminate your materials.
   • You’ll also need a water tray close at hand to rinse your developed pictures.
5. Get a safelight. These lights provide just enough light to allow you to see your workspace, without compromising your photo paper or chemicals. These lights can get quite expensive, but many photography stores have safelight bulbs available for purchase.
6. Set up your equipment in the wet side of the darkroom. This is where the chemical processes involved in photo development takes place. The equipment in this area will include:
   • Funnel
   • Trays
   • Tongs
   • Film clips (for drying processed film)
   • Graduated Cylinder
   • Chemicals (in their storage bottles)
7. Equip the dry side of your darkroom. This side of the room will house your enlarger and photo paper. The rest of the equipment here will include:
   • Film tank and reels
   • Safelight
   • Easel
   • Timer
   • Grain magnifier
   • Optional: Paper cutter used to trim your photo paper.
8. Get the necessary safety equipment. The chemicals used in the development process can be harmful for your skin, especially if you’re planning to spend several hours in your darkroom at a time. As such, make sure to wear latex gloves when handling chemicals. Additionally, a face mask will help protect your respiratory system from the fumes created when you develop your pictures.

Tips

• The only chemical you should need to buy and replace regularly is developer. A simple solution of water and white vinegar can be used for stop bath, and fixer can be re-used and recycled. When fixer develops a build-up of silver and no longer looks clear, it is time to replace it.
• Make sure there are no fluorescent lights in the darkroom as they give off radiation that will fog paper long after they have been turned off.
• If you don't have running water into your bath (final rinse), you should be sure you replace the water often, and/or move your final prints to an area where you can rinse them under running water, such as a bathtub. Prints that have not been adequately rinsed will be sticky and might smudge.

Warnings

• Certain jurisdictions don’t allow for the chemicals used in a darkroom to be dumped down the sink or flushed after use. Check with your local authorities.
• Color processing is more complicated than black and white. If you wish to try color photography, be sure your lighting, enlarger, and chemicals are safe and appropriate for color printing.

Things You'll Need

• Enlarger and Lenses
• Three Plastic Trays
• Three Sets of Tongs
• Easel Sized for your Photo Paper
• Necessary chemicals: developer and fixer
• Optional chemicals: stop bath, hardener, washing aid and wetting agent.
• Photo Paper
• Darkroom Timer
• Tanks and Reels
• Storage bottles
• Graduated Cylinders
• Film Clips
• Thermometer
• Grain Focuser
• Multigrade Printing Filters
• Contact Printing Frame
• Funnel
• Latex Gloves and Face Mask
• Safelight

Related Articles

• Develop Black and White Film
• Avoid Your Photo Being a Dark Silhouette
• Develop Color Film

Sources and Citations

See also

• Take Springtime Engagement Photos
• Develop Black and White Film
• Clean a 35mm Film Camera and Lens
• Develop Color Film
• Install a Hidden Camera
• Create an Inexpensive Photography Lightbox
• Use a Voigtlander Vito B 35mm Camera
• Use Almost Any 35mm Film Camera
• Become a Cameraman
• Make a Pinhole Lens for Your SLR Camera

Read more ...

What links here

• Build a Sound Proof Room
• Make 3D Photos
• Build a Float
• Build a Headboard for a Bed
• Build a TARDIS Replica
• Create Stereo Photographs
• Dig Out a Basement in an Existing House
• Make a Pinhole Camera
• Read Architect's Drawings